Entries under Category Spa Operation

This indicates a High Limit condition. The temperature protection system is reporting that the water temperature has exceeded safe limits, and has shut down the heater. As long as the HL switch is tripped, the heater will not come on, even if the water is actually cooling down. This does not necessarily mean that your [...]

This message is displayed to remind you to clean the filter cartridge on the spa. The display will start blinking with the CLE. Clear the message by pressing any key on the keypad.

I decided to take a loooooong leisurely soak with a friend two nights ago, and one of us managed to disable Pump 2 on my 2006 Arctic Avalanche. I do recall that when we left the spa, there was a message on the control panel, indicating it was “locked”. Not sure how we did that [...]

These steps must be followed to properly start-up or refill your spa. Ensure the electrical connections have been made in accordance with this manual. Ensure all O-Rings have been installed into unions and unions have been tightened sufficiently. Ensure all ball valves are open, and the drain has been closed. Fill the spa with water [...]

Carefully slide the pillow up and away from the spa shell. IMPORTANT: Just pulling the pillow straight out of the shell recess will damage the pillow. This is not covered under warranty. To reinstall the spa pillow, carefully slide the pillow down into the spa pillow recess.